|
TWO
WHEEL DRIVE PARTS
ENGINE
GROUP:
All
internally lubricated parts. Crankshaft and bearings, oil pump, fuel
pump, internal timing gears or chain, camshaft, camshaft bearings,
valve lifters, rocker arm assemblies and push rods, valve guides,
pistons and rings, wrist pins, connecting rods, distributor drive gear.
The engine block and cylinder heads are covered if damage is caused by
mechanical failure of an internally lubricated part. ENGINE
(Rotary):
All of the above listed parts plus rotors, rotor seals, rotor chamber,
eccentric shaft and bearings. Turbocharger/Supercharger: Factory
installed turbocharger or supercharger, including housing, and all
internal parts.
TRANSMISSION
GROUP:
The
internal parts of the manual transmission or automatic transmission and
torque converter. The automatic or manual transmission case is covered
if damaged by the failure of an internally lubricated part.
DRIVE
AXLE GROUP (Front or Rear):
Drive
axle housing including pinion bearings, side carrier bearings, ring and
pinion gears, carrier assembly, thrust washers, axles, axle bearings,
constant velocity joints, internal transaxle seal, and drive axle
housing, if damaged by the failure of an internally lubricated part.
TRANSAXLE
GROUP:
Ring
and pinion gears, drive chain and gears, carrier bearings, and
bushings. Transaxle housing and internal seals are covered, if damaged
by the failure of an internally lubricated part.
SEALS
AND GASKETS:
Seals
and gaskets are covered when replaced in conjunction with a covered
repair or if the "Seals and Gaskets Coverage" option has been selected
for covered components on vehicles with less than 100,000 miles at
Vehicle Purchase/Effective date.
FOUR
WHEEL DRIVE PARTS
All
POWERTRAIN COVERAGE, plus: Internal parts including bearings, bushings,
sprockets, chains, sleeves, and gears (excluding electrical items). The
transfer case is also covered if damage is caused by a failure of an
internally lubricated part.
|
Powertrain
Coverage Plus ~
POWER
STEERING:
Steering gear box, pump housing, rack and pinion, control valves,
bearings and shafts.
BASIC
ELECTRICAL:
Alternator/generator, starter motor, front and rear wiper motor.
TOWING:
The
Administrator will reimburse the Service Contract Holder, up to $50.00
per occurrence, for expenses in towing the vehicle, provided that the
cause of the breakdown was a covered failure of a covered component
based on the coverage plan selected. This reimbursement will be in
addition to any other reimbursement from an insurance company or auto
club.Towing benefits are available from day one (1) of your Contract.
RENTAL
CARS/SUBSTITUTE TRANSPORTATION:
The
Administrator will reimburse the Service Contract Holder for the cost
as specified below, provided that the vehicle has become disabled, due
to a covered failure of a covered component based on the coverage plan
selected and the necessary repairs require more than eight (8) hours of
labor. Reimbursement shall be made up to $30.00 per 8-hour labor
charge, with a $90.00 maximum per claim. Rental benefits are available
from day one (1) of the Vehicle Service Contract. Reimbursement is
valid only for rental from a licensed car rental agency.
|
Powertrain
& Classic Coverage Plus ~
AIR
CONDITIONING:
Compressor,
condenser, evaporator, expansion valve, and receiver drier. NOTE: If
the air conditioning system is unable to be repaired because of the
unavailability or restriction of CFCs (chlorofluorocarbons) due to the
Federal Mandate, then the Administrator does not have any further
obligation for repair of the air conditioning system under this Service
Contract. In addition, there is no obligation to install a retrofit kit
in the vehicle that would require the use of any alternate to CFCs.
HI-TECH
ELECTRICAL:
Voltage
regulator, distributor, solenoids, manually operated switches,
electronic level control compressor including its sensor and limiter
valve, electronic fuel injection sensors and injectors, electronic
ignition module, power window motors, rear window heating elements,
power mirror motors and controls, power seat motors, and power door
locks. AC-NCR-01-2006
| THIS
PROVIDES A GENERAL DESCRIPTION OF THE VEHICLE SERVICE CONTRACT
COVERAGE. PLEASE REFER TO THE VEHICLE SERVICE CONTRACT FOR COMPLETE
TERMS AND PROVISIONS. |
|
Powertrain,
Classic & Vintage Coverage Plus ~
SEALS
AND GASKETS:
This coverage option is included on vehicles with less than 100,000
miles at Vehicle Purchase/Effective date.
BRAKES:
Master
cylinder, power brake cylinder, vacuum assist booster, hydro boost,
disc brake caliper, wheel cylinders, compensating valve, brake
hydraulic lines and fittings, and hydraulic control unit. The following
ABS Components are covered: Electronic control processor, wheel speed
sensors, hydraulic pump/motor assembly, pressure modulator valve,
isolation dump valve, and accumulator.
FRONT/REAR
SUSPENSION:
Upper
and lower control arms, control arm shafts and bearings or bushings,
upper and lower ball joints, radius arm and bushings, torsion bars and
mounts or bushings, stabilizer bars, links and bushings, struts, strut
bearing plates, spindle and spindle support, wheel bearings, variable
dampening suspension, compressor, control module, actuator, solenoid,
height sensor, and mode selector switch.
COOLING:
Engine
cooling fan and motor, fan clutch, serpentine belt tensioner, radiator,
heater core, water pump, thermostat, blower motor, and hot water valve.
|
COMPREHENSIVE
COVERAGE
AUL's
Reserve Coverage is possibly the industry's most extensive coverage.
Our Reserve Coverage includes most of the factory installed mechanical
and electrical parts of the automobile For specific information about
our Reserve Coverage, please refer to the contract.
Includes POWERTRAIN,
CLASSIC, VINTAGE, and ESTATE COVERAGE
plus: Your Vehicle Service Contract will cover necessary repairs to any
FAILURE of the parts of the Covered Vehicle, except for those items
specifically listed under "WHAT IS NOT COVERED BY THIS VEHICLE SERVICE
CONTRACT".
FAILURE
refers to the
Failure of a covered part under normal service. A covered part has
failed when it can no longer perform the function for which it was
designed solely due to its condition, and not due to the action or
inaction of any non-covered parts. In addition, a Failure will be
deemed to have occurred when a covered part has worn beyond the
manufacturer's tolerances allowed for the particular Vehicle at the
mileage when the problem occurs.
|
